×

How to Replace the Drive Belt on a Troy Bilt Walk Behind Mower

Length of Clip: 2:36
This video will show you how to replace the drive belt on this Troy-Bilt walk behind mower.  Depending on your model, the instructions in this video may vary slightly.  Always be sure to check your operator's manual for detailed instructions.

Instructions

Step 1

Remove the spark plug ignition wire.

Step 2

Using the Arnold Siphon Pump, drain the fuel tank and oil tank.

Step 3

Remove the self tapping screw from the side of the deck.

Step 4

Tip the mower on its side with the air filter up.

Step 5

Wearing gloves for protection, secure the blade using the Arnold Blade Removal Tool. Remove the blade retaining bolt, then remove the blade.

Step 6

Remove the self-tapping screws that secure the engine baffle to the deck. Remove the baffle.

Step 7

Remove the self-tapping screw that secures the belt cover to the deck.

Step 8

Remove the spring from the transmission pulley to the belt cover and remove the belt cover.

Step 9

Working from the rear of the mower, remove the belt from the engine pulley, and then the transmission pulley.

Step 10

Replace with a new belt.

Step 11

First, route the belt around the engine pulley and then around the transmission pulley by threading it through the belt keeper, making sure to go through the belt keepers.

Step 12

Re-tighten the self tapping screw securing the belt cover.

Step 13

Secure the spring from the transmission to the belt cover.

Step 14

Replace the engine baffle and secure it with the self-tapping screws.

Step 15

Wearing gloves, attach the blade using the Arnold Blade removal tool. Replace the blade retaining bolt and blade adapter.

Step 16

Tip the mower back onto its wheels.

Step 17

Re-tighten the self tapping screw to the side of the deck.

Step 18

Reattach the spark plug ignition wire.



Did you find this helpful?    
http://img.youtube.com/vi/iIGCe0F_M-A/1.jpg
| P1 |