Riding Lawn Mower Oil Change Instructions

Length of Clip:  2:22

As part of routine maintenance, it's important to check and replace your riding lawn mowers' engine oil and oil filter. Performing this maintenance item will ensure your machines' engine performs as designed and will extend its service life. Follow the instructions below to inspect and replace the engine oil and oil filter.

Before you change the oil in your riding lawn mower, reference your operator's manual regarding the type and amount of oil you need. If your engine has an oil filter, also check the operator's manual regarding the correct replacement.

Note that if your riding mower is damaged from hitting an object in your yard or has complicated engine trouble, it is best to take it to a local MTD certified service dealer for repairs.




Step 1: Position the riding lawn mower

Park your riding lawn mower on a flat, level surface. Turn it off, remove the key, and lock the parking brake. Once the engine has cooled, open the hood and disconnect the spark plug wire.

Step 2: Wipe off the area around the oil fill tube, oil drain, and oil filter

Clean the area around the oil fill tube, oil drain, and oil filter. This will remove dirt and other debris that could get into the engine while you're changing the oil and oil filter.

Step 3: Remove the dipstick

Remove the engine oil dipstick from the oil fill tube and wipe it clean with a cloth. This will allow the oil to drain.

Step 4: Drain the engine oil

Place a container with a capacity of no less than 64 ounces under the oil-drain sleeve or position it to catch the oil from the Arnold Siphon Pump. Remove the drain plug, and drain the oil into the container. When the oil has completely drained, wipe the area around the oil drain and replace the drain plug. Remove the drain sleeve or Arnold Siphon Pump.

Step 5: Replace the oil filter

If the unit is equipped with an oil filter, remove and dispose of it properly. Wipe the area around the oil filter housing with a clean cloth. To provide the proper seal, lightly coat the new oil filter's gasket with fresh engine oil before installing it. Install the oil filter by hand until the gasket touches the oil filter adapter. Then, tighten the filter using an oil filter wrench. Reference your operator's manual for further instructions on tightening the filter properly.

Step 6: Replace the engine oil

Fill the engine with oil - make sure you use the exact type and amount specified in your operator's manual. Do not overfill, as this can cause excessive smoking, as well as harm to the engine.

Step 7: Check for leaks

After adding oil to the engine, wait one to two minutes, and then check to ensure oil is not leaking from around the oil filter and drain plug.

Step 8: Check engine oil level

Replace and tighten the dipstick. Then, remove the dipstick and check the oil level. It should be at the top of the "full" indicator on the dipstick. If required, add oil and re-check. If full, wipe the dipstick clean with a cloth, replace the dipstick, and tighten.

Step 9: Re-connect the spark plug

Re-connect the spark plug wire to the spark plug.

Fix equipment issues quickly

When you need parts for your riding lawn mower, you can use the MTD Genuine Parts Part Finder to find the correct one. Common parts include:

Shop equipment and parts

Resolving outdoor power equipment problems as soon as they arise will prolong the life of your machine. Troubleshoot riding lawn mower problems using our symptom guide.

 

The MTD Genuine Parts Knowledge Center provides do-it-yourself instructions for performing many basic maintenance items, including replacing cutting blades, drive and deck belts, and engine oil. If you find your machine has a bigger problem, use our service locator to find a qualified MTD service provider in your area.

 

Part Finder

Don't know your model number?

You can use the Part Finder to help find your model and the right part for your machine.

Find Matching Models